RM RM Eye Bedienerhandbuch PDF herunterladen (Seite 63)

BASIC OPERATIONS

6 After the alignment bar is displayed, move the main body slowly towards the patient.

Measurement is done and the measurement value is displayed on the monitor screen.

DISPLAYING MEASUREMENT VALUES

Data of the latest measurement are displayed on the monitor screen.

Figures only: Measurement was done correctly.

Figures+*: The reliability of measurement is low.

ERROR: Measurement was not done correctly.

• To stop auto start

Press the , and release it after hearing the buzzer

sounds twice. Auto measurement is stopped. To return to auto measurement,

press the again.

After stopping the measurement, the measurement result is printed out by

pressing the .

• To automatically print the measurement result (available at auto start mode

only)

If YES is selected for auto print in the initial setting, press the

after right and left measurements are finished.

The buzzer sounds twice, and the measurement result is printed out automati-

cally.

NOTICE

• If measurement is not possible under auto start mode (this may

occur when the cornea condition is not good), measure under

manual start mode.

For messages on the monitor screen, see “Messages given during measurement”

on page 73.

S-1.00 C A

A180

H 7.71 V 7.70

CYL

12.00

R01 00

0001

(-)

00 00

MEASUREMENT SWITCH

AUTO START

PRINT SWITCH

MEASUREMENT SWITCH

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 91 92

Keine Kommentare

RM RM Eye Bedienerhandbuch Seite 63